Proceedings Article | 9 June 2017
KEYWORDS: Calibration, Single photon detectors, Sensors, Waveguides, Power meters, Photodetectors, Absorption, Standards development, Photon counting, Current controlled current source
Calibration of fiber-coupled single-photon detectors usually requires knowledge of the input photon flux inside the fiber and/or knowledge of the linearity of a reference power meter. Many approaches have been presented in the past to accurately measure the photon detection probability of a single photon detector [1-6]. Under certain assumptions, one can utilize waveguide-coupled single photon detectors and a series of photon-counting measurements and a single-photon source to calibrate the detection efficiency of a single photon detector without the need of a reference power meter and the knowledge of the incoming photon flux. Here, this method is presented. Furthermore, if a reference detector is used, the detection efficiency of all evanescently coupled waveguide detectors can be measured, and the measurement outcome does not depend on splicing or fiber connection losses within in the setup, i.e., the measurement is setup-independent. In addition, the method, when using a reference detector, can be utilized to measure and distinguish between the absorption of a waveguide-coupled single photon detector and its internal detection efficiency.
[1] A. J. Miller et al, Opt. Express 19, 9102–9110 (2011)
[2] I. Muller et al., Metrologia 51, S329 (2014).
[3] A. L. Migdall, Instrumentation and Measurement, IEEE Transactions on 50, 478–481 (2001).
[4] S. V. Polyakov, A. L. Migdall, Optics Express 15, 1390–1407 (2007).
[5] A. Avella et al., Optics Express 19, 23249–23257 (2011).
[6] T. Lunghi et al., Opt. Express 22, 18078-18092 (2014)
