A major concern in the development of microelectromechanical systems (MEMS) is the presence of residual stress. This
stress, which is produced during the fabrication of multi-layer thin-film structures, can significantly affect the
performance of micro-scale devices. Though experimental measurement techniques are accurate, actual stress
measurements can vary dramatically from run to run and wafer to wafer. For this reason, the modeling of this stress can
be a challenging task. Past work has often focused on experimental, static techniques for determining residual-stress
levels in single-layer and bi-layer structures. In addition, in prior studies, the focus has primarily been on residual-stress
measurements in thin films as they are being deposited and prior to the release of a particular device. In this effort,
residual stresses in MEMS resonators are characterized pre- and post-micro-machining and release of the structures.
This is accomplished by applying three residual-stress identification techniques. The first technique, which is based on
wafer-bow measurements and Stoney's formula, is suited for determining the residual stresses in thin film layers as they
are being deposited and before the occurrence of a micro-machining or release process. In the second technique, a static
parametric identification technique, device deflection data is made use of to approximate individual device residual
stress immediately after release of a structure. The third technique, a dynamic parametric identification technique, which
can be based on linear or nonlinear frequency response data can be used to estimate device residual stress immediately
after release and after the device has been polarized. The results obtained by using these techniques are used to develop
an understanding of how geometry, fabrication, release and polarization of resonators affect the stress state in a
piezoelectric device. The results, which show that the stress levels can be quite different after a device has been released
and poled, point to the importance of considering parameter identification schemes such as those described in this effort
for identifying residual stresses in multi-layer, micro-structures.
A major concern in the development of microelectromechanical systems (MEMS) is the presence of residual stress.
Residual stress, which is produced during the fabrication of multi-layer thin-film structures, can significantly affect the
performance of micro-scale devices. Though experimental measurement techniques are accurate, actual stress
measurements can vary dramatically from run to run and wafer to wafer. For this reason, the modeling of this stress can
be a challenging task. Past work has often focused on experimental, static techniques for determining residual stress
levels in single-layer and bi-layer structures. In addition, these past studies have concentrated on residual stress
measurements in thin films as they are being deposited and prior to the release of a particular device. In this effort, three
techniques are used for determining residual stress levels in four-layer piezoelectrically driven cantilevers and resonator
structures. The first technique is a static technique that is based on wafer bow measurements and Stoney's formula. The
second technique is a dynamic technique that is based on parameter identification from nonlinear frequency-response
data. The third technique is also a static technique based on parameter identification from static device deflection
measurements. The devices studied, which are piezoelectric devices, are fabricated with varying lengths and widths.
The results obtained from these three techniques will be compared and discussed, and it is expected that this work will
enable the characterization of residual stress in micro-structures after they have been released.
Access to the requested content is limited to institutions that have purchased or subscribe to SPIE eBooks.
You are receiving this notice because your organization may not have SPIE eBooks access.*
*Shibboleth/Open Athens users─please
sign in
to access your institution's subscriptions.
To obtain this item, you may purchase the complete book in print or electronic format on
SPIE.org.
INSTITUTIONAL Select your institution to access the SPIE Digital Library.
PERSONAL Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.