2 September 2014 Few-mode erbium-doped fiber amplifier design method based on the signal-pump overlap integral
Adolfo F. Herbster, Murilo A. Romero
Author Affiliations +
Abstract
Space-division multiplexing allows an increase of link capacity by using either multicore or single-core few-mode (FM) optical fibers. In the case of FM systems, each mode carries its own data stream and long-haul transmission can be hampered by the use of conventional erbium-doped fiber amplifiers (EDFAs), since because of distinct field profile configurations, each mode experiences a different value of optical gain. The role of the FM-EDFA designer, usually done by solving rate and propagation equations, is to define both the fiber cross-section and the pumping configuration to provide the best possible mode equalization of optical gain and noise figure. An optimization method is proposed here based on the definition of a figure of merit related to the equalization of the pump-mode signal overlap integral, significantly reducing computation time and allowing a multiobjective optimization approach. The results obtained were validated against the solution provided by the full set of rate and propagation equations and we conducted an FM-EDFA optimization case study. Our double-ring Er doping profile design requires a single 180-mW LP11 pump to provide a mean gain of 21.3 dB, within 0.6 dB of equalization for each of the four modes considered.
© 2014 Society of Photo-Optical Instrumentation Engineers (SPIE) 0091-3286/2014/$25.00 © 2014 SPIE
Adolfo F. Herbster and Murilo A. Romero "Few-mode erbium-doped fiber amplifier design method based on the signal-pump overlap integral," Optical Engineering 53(9), 096101 (2 September 2014). https://doi.org/10.1117/1.OE.53.9.096101
Published: 2 September 2014
Lens.org Logo
CITATIONS
Cited by 15 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Doping

Fiber amplifiers

Erbium

Optical amplifiers

Optical engineering

Fermium

Frequency modulation

RELATED CONTENT

On the design of few mode Er doped fiber amplifiers...
Proceedings of SPIE (May 01 2014)
Four-mode semiconductor optical amplifier
Proceedings of SPIE (March 08 2016)
30 dB gain at 1500 nm in S band erbium...
Proceedings of SPIE (June 17 2003)

Back to Top