Calibration of physical resist models for simulation of extreme ultraviolet lithography

Ulrich K. Klostermann; Thomas Muelders; Thomas Schmöller; Gian F. Lorusso; Eric Hendrickx

doi:10.1117/1.3533324

1 January 2011 Calibration of physical resist models for simulation of extreme ultraviolet lithography

Ulrich K. Klostermann, Thomas Muelders, Thomas Schmöller, Gian F. Lorusso, Eric Hendrickx

Author Affiliations +

Journal of Micro/Nanolithography, MEMS, and MOEMS, Vol. 10, Issue 1, 013007 (January 2011). https://doi.org/10.1117/1.3533324

Abstract

We have calibrated a physical resist model for extreme ultra-violet (EUV) lithography, and discuss model calibration and validation over a larger set of structures. The study is conducted on an extensive data set, collected at imec, for ShinEtsu resist SEVR-59 exposed on the ASML EUV alpha demo tool (ADT). The data set included more than a thousand measured feature widths (critical dimensions or CD) on wafer and mask. We address practical aspects of the calibration, such as the speed of calibration and selection of calibration input. The model is calibrated by simultaneously fitting 12 process windows of features with different mask CD (32, 36, 40 nm), orientation (horizontal, vertical), and pitch (dense, isolated). The smallest feature size at nominal process condition is a 32 nm CD at a dense pitch of 64 nm. Mask CD metrology was used to fit the model versus actually measured mask CD's. Cross-sectional scanning electron microscopy information was included in the calibration, to tune the simulated resist loss and sidewall angle. The achieved calibration root-mean-squared (RMS) error is ∼1.0 nm. We discuss the elements that were essential to obtain a well calibrated model. We discuss the impact of 3-D mask effects on the Bossung tilt. We demonstrate that a correct representation of the flare level during the calibration is key in order to achieve a high CD predictability at various flare levels. Although the model calibration is performed on a limited subset of the measurement data collected on 12 different patterns (one dimensional structure process windows), its accuracy is validated on a large number of patterns used to calibrate models for optical proximity correction―several hundred different feature types, at nominal dose and focus conditions. These were not included in the calibration; validation RMS results as small as 1 nm can be reached. Furthermore, we study the model's extendibility to two-dimensional end of line structures.

©(2011) Society of Photo-Optical Instrumentation Engineers (SPIE)

Citation Download Citation

Ulrich K. Klostermann, Thomas Muelders, Thomas Schmöller, Gian F. Lorusso, and Eric Hendrickx "Calibration of physical resist models for simulation of extreme ultraviolet lithography," Journal of Micro/Nanolithography, MEMS, and MOEMS 10(1), 013007 (1 January 2011). https://doi.org/10.1117/1.3533324

Published: 1 January 2011

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

;

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE