Presentation + Paper
21 October 2016 High-speed tomography using pink beam at GeoSoilEnviroCARS
Author Affiliations +
Abstract
Synchrotron microtomography typically uses monochromatic beams, because these avoid beam-hardening artifacts and allow imaging above and below the absorption edges of specific elements. However, the monochromator greatly reduces the flux on the sample, and thus increases the data collection time. An alternative is to eliminate the monochromator, instead using absorbers to remove low-energy x-rays and reflection from a mirror to remove high-energy x-rays. This produces a pink beam with a large energy bandwidth and more than 1000 times greater flux. This is useful for dynamic studies, where an entire 3-D dataset can be collected in just a few seconds. We have implemented pink beam tomography at the 13-BM-D beamline at the GeoSoilEnviroCARS sector 13 at the Advanced Photon Source. A key component of such a system is a high-speed detector that can collect over 100 frames/s with excellent signal/noise. We are using a new generation of inexpensive CMOS detectors with very low read noise, large full-well capacity, and high speed. The system performs well, and first experiments in studying fluid imbibition and drainage are presented.
Conference Presentation
© (2016) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Mark L. Rivers "High-speed tomography using pink beam at GeoSoilEnviroCARS", Proc. SPIE 9967, Developments in X-Ray Tomography X, 99670X (21 October 2016); https://doi.org/10.1117/12.2238240
Lens.org Logo
CITATIONS
Cited by 10 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Mirrors

X-rays

Cameras

Tomography

Aluminum

Cesium

Data acquisition

Back to Top