Paper
22 July 2016 GMTIFS: the adaptive optics beam steering mirror for the GMT integral-field spectrograph
J. Davies, G. Bloxham, R. Boz, D. Bundy, B. Espeland, B. Fordham, J. Hart, N. Herrald, J. Nielsen, R. Sharp, A. Vaccarella, C. Vest, P. J. Young
Author Affiliations +
Abstract
To achieve the high adaptive optics sky coverage necessary to allow the GMT Integral-Field Spectrograph (GMTIFS) to access key scientific targets, the on-instrument adaptive-optics wavefront-sensing (OIWFS) system must patrol the full 180 arcsecond diameter guide field passed to the instrument. The OIWFS uses a diffraction limited guide star as the fundamental pointing reference for the instrument. During an observation the offset between the science target and the guide star will change due to sources such as flexure, differential refraction and non-sidereal tracking rates. GMTIFS uses a beam steering mirror to set the initial offset between science target and guide star and also to correct for changes in offset. In order to reduce image motion from beam steering errors to those comparable to the AO system in the most stringent case, the beam steering mirror is set a requirement of less than 1 milliarcsecond RMS. This corresponds to a dynamic range for both actuators and sensors of better than 1/180,000.

The GMTIFS beam steering mirror uses piezo-walk actuators and a combination of eddy current sensors and interferometric sensors to achieve this dynamic range and control. While the sensors are rated for cryogenic operation, the actuators are not. We report on the results of prototype testing of single actuators, with the sensors, on the bench and in a cryogenic environment. Specific failures of the system are explained and suspected reasons for them. A modified test jig is used to investigate the option of heating the actuator and we report the improved results. In addition to individual component testing, we built and tested a complete beam steering mirror assembly. Testing was conducted with a point source microscope, however controlling environmental conditions to less than 1 micron was challenging. The assembly testing investigated acquisition accuracy and if there was any un-sensed hysteresis in the system. Finally we present the revised beam steering mirror design based on the outcomes and lessons learnt from this prototyping.
© (2016) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
J. Davies, G. Bloxham, R. Boz, D. Bundy, B. Espeland, B. Fordham, J. Hart, N. Herrald, J. Nielsen, R. Sharp, A. Vaccarella, C. Vest, and P. J. Young "GMTIFS: the adaptive optics beam steering mirror for the GMT integral-field spectrograph", Proc. SPIE 9912, Advances in Optical and Mechanical Technologies for Telescopes and Instrumentation II, 991217 (22 July 2016); https://doi.org/10.1117/12.2231560
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Sensors

Actuators

Mirrors

Beam steering

Stars

Adaptive optics

Interferometry

RELATED CONTENT

HARMONI at ELT: development of the high-contrast module
Proceedings of SPIE (August 29 2022)
LINC NIRVANA how to get a 23 m wavefront...
Proceedings of SPIE (October 25 2004)
Development of a 2D precision cryogenic chopper for METIS
Proceedings of SPIE (September 13 2012)
NSO/SP adaptive optics program
Proceedings of SPIE (August 01 1990)

Back to Top