Low-profile and wearable energy harvester based on plucked piezoelectric cantilevers

Michele Pozzi; Heather J. A. Almond; Glenn J. T. Leighton; Roy J. Moriarty

doi:10.1117/12.2179574

21 May 2015 Low-profile and wearable energy harvester based on plucked piezoelectric cantilevers

Michele Pozzi, Heather J. A. Almond, Glenn J. T. Leighton, Roy J. Moriarty

Proceedings Volume 9517, Smart Sensors, Actuators, and MEMS VII; and Cyber Physical Systems; 951706 (2015) https://doi.org/10.1117/12.2179574
Event: SPIE Microtechnologies, 2015, Barcelona, Spain

Abstract

The Pizzicato Energy Harvester (EH) introduced the technique of frequency up-conversion to piezoelectric EHs wearable on the lateral side of the knee-joint. The operation principle is to pluck the piezoelectric bimorphs with plectra so that they produce electrical energy during the ensuing mechanical vibrations. The device presented in this work is, in some ways, an evolution of the earlier Pizzicato: it is a significantly more compact and lighter device; the central hub holds 16 piezoelectric bimorphs shaped as trapezoids, which permits a sleek design and potentially increased energy output for the same bimorph area. Plectra were formed by Photochemical Machining of a 100-μm-thick steel sheet. To avoid the risk of short-circuiting, the plectra were electrically passivated by sputtering a 100 nm layer of ZrO₂. Bench tests with the steel plectra showed a very large energy generation. Polyimide plectra were also manufactured with a cutting plotter from a 125μm-thick film. Besides bench tests, a volunteer wore the device while walking on flat ground or climbing stairs, with a measured energy output of approximately 0.8 mJ per step. Whereas most of the tests were performed by the traditional method of discharging the rectified output from the EH onto a resistive load, tests were performed also with a circuit offering a stabilised 3.3 V supply. The circuit produced a stable 0.1 mA supply during running gait with kapton plectra.

Citation Download Citation

Michele Pozzi, Heather J. A. Almond, Glenn J. T. Leighton, and Roy J. Moriarty "Low-profile and wearable energy harvester based on plucked piezoelectric cantilevers", Proc. SPIE 9517, Smart Sensors, Actuators, and MEMS VII; and Cyber Physical Systems, 951706 (21 May 2015); https://doi.org/10.1117/12.2179574

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available