One-step surface modification of poly(dimethylsiloxane) by undecylenic acid

Jinwen Zhou; Steven J. P. McInnes; Abdul Mutalib Md Jani; Amanda V Ellis; Nicolas H. Voelcker

doi:10.1117/12.810101

30 December 2008 One-step surface modification of poly(dimethylsiloxane) by undecylenic acid

Jinwen Zhou, Steven J. P. McInnes, Abdul Mutalib Md Jani, Amanda V Ellis, Nicolas H. Voelcker

Author Affiliations +

Proceedings Volume 7267, Smart Materials V; 726719 (2008) https://doi.org/10.1117/12.810101
Event: SPIE Smart Materials, Nano- and Micro-Smart Systems, 2008, Melbourne, Australia

Abstract

Poly(dimethylsiloxane) (PDMS) is a popular material for microfluidic devices due to its relatively low cost, ease of fabrication, oxygen permeability and optical transmission characteristics. However, its highly hydrophobic surface is still the main factor limiting its wide application, in particular as a material for biointerfaces. A simple and rapid method to form a relatively stable hydrophilised PDMS surface is reported in this paper. The PDMS surface was treated with pure undecylenic acid (UDA) for 10 min, 1 h and 1 day at 80 °C in a sealed container. The effects of the surface modification were investigated using water contact angle (WCA) measurements, Fourier transform infrared spectroscopy in attenuated total reflection mode (FTIR-ATR), and streaming zeta-potential analysis. The water contact angle of 1 day UDAmodified PDMS was found to decrease from that of native PDMS (110 °) to 75 °, demonstrating an increase in wettability of the surface. A distinctive peak at 1715 cm-1 in the FTIR-ATR spectra after UDA treatment was representative of carboxylation of the PDMS surface. The measured zeta-potential (ζ) at pH 4 changed from -27 mV for pure PDMS to -19 mV after UDA treatment. In order to confirm carboxylation of the surface visually, Lucifer Yellow CH fluorescence dye was reacted via a condensation reaction to the 1 day UDA modified PDMS surface. Fluorescent microscopy showed Lucifer Yellow CH fluorescence on the carboxylated surface, but not on the pure PDMS surface. Stability experiments were also performed showing that 1 day modified UDA samples were stable in both MilliQ water at 50 °C for 17 h, and in a desiccator at room temperature for 19.5 h.

Citation Download Citation

Jinwen Zhou, Steven J. P. McInnes, Abdul Mutalib Md Jani, Amanda V Ellis, and Nicolas H. Voelcker "One-step surface modification of poly(dimethylsiloxane) by undecylenic acid", Proc. SPIE 7267, Smart Materials V, 726719 (30 December 2008); https://doi.org/10.1117/12.810101

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

;

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE