Paper
10 May 2007 AFB CVD diamond composites with laser materials
Huai-Chuan Lee, Helmuth Meissner
Author Affiliations +
Abstract
The thermal conductivity of CVD diamond with about 18-25 W/cm.K at room temperature is one of the properties that makes diamond a unique material. Since thermal management of solid state lasers becomes increasingly difficult when scaling up to high average power, CVD diamond is an ideal heat spreader to conduct heat away to a heat sink. At the same time, diamond is transparent between 230nm and the far infrared, with two-photon absorption bands between 2.5 and 6 μm. Adhesive-Free Bonding (AFB®) of CVD diamond sheet has been demonstrated to be possible because Van der Waals attractive forces constitute the principal bonding mechanism of AFB® composites. The coefficient of thermal expansion of CVD diamond is with 0.8 - 1.0 x 10-6/°C much lower than any of the common solid state laser media, with YAG being about 8.2 x 10-6/°C. The non-localized nature of Van der Waals bonds allows almost perfect stress equilibration without delamination, while any other bonding technique would be expected to result in highly stressed composites. Bonding mechanisms, experimental observation of stress relief and parameters for successful AFB® CVD diamond/ single crystal composites at the interface will be reported, with relevance for disk, slab and waveguide solid state laser geometries at ambient and cryogenic temperature.
© (2007) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Huai-Chuan Lee and Helmuth Meissner "AFB CVD diamond composites with laser materials", Proc. SPIE 6552, Laser Source Technology for Defense and Security III, 655208 (10 May 2007); https://doi.org/10.1117/12.719467
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Chemical vapor deposition

Diamond

Composites

YAG lasers

Crystals

Surface finishing

Interfaces

Back to Top