Paper
19 January 2007 Development of wireless MEMS sensor for RFID tag and temperature/pressure monitoring
Wen Wang, K. Lee, T. Kim, S. Yang
Author Affiliations +
Abstract
This paper presents an integrated multifunctional microsensor based on 440MHz surface acoustic wave (SAW) reflective delay line on 41° YX LiNbO3. A pressure sensor, a temperature sensor, and radio frequency identification (RFID) tag were integrated on two-bonded piezoelectric substrates. The pressure sensor was placed on the top plate, whereas the RFID tag and temperature sensor were located on the bottom substrate. Finite Element Methods (FEM) and Coupling of mode (COM) modeling were performed to extract the optimal design parameters before fabrication. The fabricated sensor was wirelessly characterized through the Network Analyzer. Sharp reflection peaks with high S/N ratio were observed. Obtained temperature and pressure sensitivity are ~10°/°C and ~2.9°/kPa, respectively.
© (2007) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Wen Wang, K. Lee, T. Kim, and S. Yang "Development of wireless MEMS sensor for RFID tag and temperature/pressure monitoring", Proc. SPIE 6463, Reliability, Packaging, Testing, and Characterization of MEMS/MOEMS VI, 64630Q (19 January 2007); https://doi.org/10.1117/12.721021
Lens.org Logo
CITATIONS
Cited by 2 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Reflectors

Sensors

Phase shifts

Temperature sensors

Finite element methods

Network security

Temperature metrology

RELATED CONTENT


Back to Top