Embedding viscoelastic damping materials in low-cost VARTM composite structures

M. J. Robinson; J. B. Kosmatka

doi:10.1117/12.600421

16 May 2005 Embedding viscoelastic damping materials in low-cost VARTM composite structures

M. J. Robinson, J. B. Kosmatka

Proceedings Volume 5760, Smart Structures and Materials 2005: Damping and Isolation; (2005) https://doi.org/10.1117/12.600421
Event: SPIE Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring, 2005, San Diego, California, United States

Abstract

It has been well established that using viscoelastic damping materials in structural applications can greatly reduce the dynamic response and thus improve structural fatigue life. Previously these materials have been used to solve vibration problems in metallic structures, where the damping material is attached to the structure and then a stiff outer layer is attached to promote shear deformation in the damping material. More recently, these materials have been used successfully in expensive aerospace composite structures, where the damping material is embedded between plies of prepreg graphite/epoxy prior to being cured in a high-temperature, high-pressure autoclave. The current research involves embedding these damping layers into low-cost composite structures fabricated using the Vacuum Assisted Resin Transfer Molding (VARTM) process. The damping layers are perforated with a series of small holes to allow the resin to flow through the damping layer and completely wet-out the structure. Experimental fabrication, vibration testing, and stiffness testing investigate the effect of hole diameter versus hole spacing. Results show that the damping and stiffness can be very sensitive to perforation spacing and size. It is shown that for closely spaced perforations (95% damping area) that damping increases by only a factor of 2.2 over the undamped plate. However, for greater perforation spacing (99.7% damping area) the damping is increased by a factor of 14.3. Experimental results as well as practical design considerations for fabricating damped composite structures using the VARTM process are presented.

Citation Download Citation

M. J. Robinson and J. B. Kosmatka "Embedding viscoelastic damping materials in low-cost VARTM composite structures", Proc. SPIE 5760, Smart Structures and Materials 2005: Damping and Isolation, (16 May 2005); https://doi.org/10.1117/12.600421

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available