Paper
4 May 2005 Optimization of equipment for 193-nm immersion processing
Author Affiliations +
Abstract
For immersion lithography at 193 nm, there is concern that the immersion of resist in water during exposure might cause water to penetrate the resist or resist components to dissolve into water, or that water remaining after exposure might affect subsequent processes. It is also thought that the same concerns are likely to be felt even if using a protective top coat. In this paper, we report on three key findings. First, after immersing resist in water using virtual immersion methods and evaluating the effect of water on critical dimension (CD) and defects, it was found that CD changes and defects increase. Second, as a result of performing the same evaluation when using a top coat, it was found that CD changes and defects increase despite top-coat application. Finally, a significant amount of knowledge can be obtained for the development of optimal 193-nm immersion lithography equipment as a result of wafer processing using real inline tools for immersion exposure and coating/developing.
© (2005) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Takafumi Niwa, Masashi Enomoto, Satoru Shimura, Hideharu Kyoda, Tetsu Kawasaki, and Junichi Kitano "Optimization of equipment for 193-nm immersion processing", Proc. SPIE 5753, Advances in Resist Technology and Processing XXII, (4 May 2005); https://doi.org/10.1117/12.598686
Lens.org Logo
CITATIONS
Cited by 3 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Thin film coatings

Semiconducting wafers

Immersion lithography

Water

Photoresist processing

Critical dimension metrology

Coating

Back to Top