Ring test aberration determination and device lithography correlation

Cesar M. Garza Sr.; Will Conley; Bernard J. Roman; Mike Schippers; James Foster; Jan Baselmans; Kevin D. Cummings; Donis G. Flagello

doi:10.1117/12.435749

14 September 2001 Ring test aberration determination and device lithography correlation

Cesar M. Garza Sr., Will Conley, Bernard J. Roman, Mike Schippers, James Foster, Jan Baselmans, Kevin D. Cummings, Donis G. Flagello

Author Affiliations +

Proceedings Volume 4346, Optical Microlithography XIV; (2001) https://doi.org/10.1117/12.435749
Event: 26th Annual International Symposium on Microlithography, 2001, Santa Clara, CA, United States

Abstract

The exposure tool is a critical enabler to continue improving the packing density and transistor speed in the semiconductor industry. In addition to increasing resolution (improving packing density), a scanner is expected to provide tight linewidth control across the chip, ACLV (transistor speed). An important component of ACLV is lens aberrations. Recently techniques that allow the measurement in-situ of aberrations using Zernike coefficients have become available. We have measured the first 25 Zernike coefficients in two ASML PAS 500/700D DUV Step & Scan systems. The measured Zernikes are in agreement with PMI (Phase Measurement Interferometry) data collected at the lens manufacturer within 3.8 nm or less. We find good agreement between the variation of the Z₅ (first order astigmatism) coefficient and the optimum focus offset between horizontal and vertical lines measured using FOCAL. There is also good agreement between Z₅ and the linewidth difference between 160 nm horizontal and vertical lines with a 330 nm pitch. The lines were printed using an NA equals 0.68, (sigma) equals 0.70 on 3,800 angstrom of resist on top of an inorganic BARC. We find good correlation between the Z₇ coefficient (first order coma) and linewidth variation across the slit. We also found that the effect of the aberrations as measured by linewidth range is a function of pitch. Linewidth range decreases as the duty ratio increases, reaching a minimum at a duty ratio of 1:1.44, and then increases again as the lines become isolated. This is surprising because these intermediate pitches also have the smallest focus-exposure window. We conclude that knowing the Zernike coefficients provides us with a very powerful tool to characterize our exposure tools. However to fully realize the benefit of this new tool we must improve the accuracy of our simulation tools.

Citation Download Citation

Cesar M. Garza Sr., Will Conley, Bernard J. Roman, Mike Schippers, James Foster, Jan Baselmans, Kevin D. Cummings, and Donis G. Flagello "Ring test aberration determination and device lithography correlation", Proc. SPIE 4346, Optical Microlithography XIV, (14 September 2001); https://doi.org/10.1117/12.435749

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available