Paper
15 May 2000 How small should pixel size be?
Ting Chen, Peter Bert Catrysse, Abbas El Gamal, Brian A. Wandell
Author Affiliations +
Abstract
Pixel design is a key part of image sensor design. After deciding on pixel architecture, a fundamental tradeoff is made to select pixel size. A small pixel size is desirable because it results in a smaller die size and/or higher spatial resolution; a large pixel size is desirable because it results in higher dynamic range and signal-to-noise ratio. Given these two ways to improve image quality and given a set of process and imaging constraints an optimal pixel size exists. It is difficult, however, to analytically determine the optimal pixel size, because the choice depends on many factors, including the sensor parameters, imaging optics and the human perception of image quality. This paper describes a methodology, using a camera simulator and image quality metrics, for determining the optimal pixel size. The methodology is demonstrated for APS implemented in CMOS processes down to 0.18 (mu) technology. For a typical 0.35 (mu) CMOS technology the optimal pixel size is found to be approximately 6.5 micrometers at fill factor of 30%. It is shown that the optimal pixel size scales with technology, btu at slower rate than the technology itself.
© (2000) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Ting Chen, Peter Bert Catrysse, Abbas El Gamal, and Brian A. Wandell "How small should pixel size be?", Proc. SPIE 3965, Sensors and Camera Systems for Scientific, Industrial, and Digital Photography Applications, (15 May 2000); https://doi.org/10.1117/12.385463
Lens.org Logo
CITATIONS
Cited by 85 scholarly publications and 3 patents.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Modulation transfer functions

Signal to noise ratio

Sensors

Spatial frequencies

Image sensors

Image processing

Image quality

Back to Top