Paper
11 August 1999 Polymer residue formation in vias caused by plasma etching of underlying titanium-rich films
Gus J. Colovos, John F. DiGregorio, Ralph N. Wall
Author Affiliations +
Abstract
Thick polymer residues were observed in vias after plasma etching (in a CF4/CHF3/N2 atmosphere) and subsequent photoresist strip. It was determined that these hardened residues were caused by the etching of underlying titanium-rich films (such as titanium, titanium nitride, titanium tungsten, and titanium silicide) during the via over etch. Polymer residues were not seen when the underlying film was aluminum or tungsten. In addition, hardened polymer formation was not observed when the total amount of titanium-rich metal being etched was decreased below a certain threshold value. The results of this work indicated that when relatively large amounts of titanium- rich films were etched using standard CF4/CHF3/N2 oxide etch chemistries by, thick polymer residues formed in the vias. Because the residues were metal-rich, they were insensitive to changes in the CF4/CHF3 ratio. It was determined that the most straightforward way of eliminating the residues was by using an amine based photoresist strip solvent (EKC 265). However, it was found that the EKC 265 must be properly rinsed in order to achieve acceptable via chain resistance.
© (1999) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Gus J. Colovos, John F. DiGregorio, and Ralph N. Wall "Polymer residue formation in vias caused by plasma etching of underlying titanium-rich films", Proc. SPIE 3883, Multilevel Interconnect Technology III, (11 August 1999); https://doi.org/10.1117/12.360587
Lens.org Logo
CITATIONS
Cited by 1 scholarly publication.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Semiconducting wafers

Metals

Etching

Polymers

Titanium

Polymer thin films

Plasma etching

Back to Top