Paper
26 July 1999 ARC technology to minimize CD variations during emitter structuring: experiment and simulation
Joachim J. Bauer, G. Drescher, Ulrich A. Jagdhold, Ulrich Haak, T. Skaloud
Author Affiliations +
Abstract
Coming out of our in-house SiGe-hetero-bipolar-technology we found that the variations of some of the important electrical parameter like the emitter current are depending on the variations of the critical dimension (CD) during the emitter structuring and this effect is mainly caused by the used i-line photolithography. To minimize the CD variations we used anti reflective coatings. For comparison reasons we applied three different resist technologies, without any ARC, with top ARC (TARC), and with bottom ARC (BARC). During our 0.4 micrometers emitter structuring the CD variations could be reduced down to +/- 40-30 nm for the resists and the resist/TARC combination. The smallest CD variation +/- nm was found by applying the BARC Resist Technology. As an optimization strategy calculations of the resist reflection and the resist absorption were very helpful.
© (1999) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Joachim J. Bauer, G. Drescher, Ulrich A. Jagdhold, Ulrich Haak, and T. Skaloud "ARC technology to minimize CD variations during emitter structuring: experiment and simulation", Proc. SPIE 3679, Optical Microlithography XII, (26 July 1999); https://doi.org/10.1117/12.354303
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Critical dimension metrology

Absorption

Oxides

Coating

Antireflective coatings

Optical lithography

Reflection

Back to Top