Paper
27 May 1982 Use Of Reflective Baffles For Control Of Aperture Heat Loads And Stray Radiation
D. F. Rock, A. D. Warren, A. J. Lewanski
Author Affiliations +
Proceedings Volume 0330, Optical Systems Engineering II; (1982) https://doi.org/10.1117/12.934257
Event: 1982 Los Angeles Technical Symposium, 1982, Los Angeles, United States
Abstract
The traditional approach to design of baffles for suppressing stray radiation uses a tube lined with black diffuse baffles to eliminate single-scatter paths to the primary optics. However, the black baffles can absorb an excessive amount of heat and contribute to increased background radiation at infrared wavelengths if used in proximity to relatively intense off-axis radiation sources, such as the sun in some sensor applications or the earth itself in other applications. This paper describes a baffle tube design using reflective baffles of elliptical cross section. The design rejects most of the load, but intrinsic limitations allow some skew rays to land on surfaces facing the primary, resulting in increased scatter. The benefits of decreased aperture load must be carefully weighed against increases in background due to scatter. Fabrication tolerances must also be considered, because they will degrade performance. This paper addresses these tradeoffs and describes some analysis methods for evaluating specular baffle designs.
© (1982) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
D. F. Rock, A. D. Warren, and A. J. Lewanski "Use Of Reflective Baffles For Control Of Aperture Heat Loads And Stray Radiation", Proc. SPIE 0330, Optical Systems Engineering II, (27 May 1982); https://doi.org/10.1117/12.934257
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Reflectivity

Sensors

Tolerancing

Systems modeling

Optical systems engineering

Scattering

Diffraction

RELATED CONTENT


Back to Top