PERSONAL Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.
Laser additive manufacturing (LAM) is layer by layer built up a 3-D part using either a bed or stream of powdered material. In this paper, the heat transfer and melt solidification of iron powder in the direct metal laser sintering (DMLS) process with low laser powers have been experimental investigated. The experimental results of various properties of each layer and properties among the multiple layers due to the laser power, the scanner rate, of the frequency of the laser pulse, have been shown and discussed. The process will be improved by numerical modeling in the future.
S. Thongsuwan,A. Ranusawud,P. Limsuwan,S. Jaiyen, andP. Buranasiri
"Investigation of direct metal laser sintering process of iron powder with low laser power", Proc. SPIE 10523, Laser 3D Manufacturing V, 105231C (26 February 2018); https://doi.org/10.1117/12.2299654
ACCESS THE FULL ARTICLE
INSTITUTIONAL Select your institution to access the SPIE Digital Library.
PERSONAL Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.
The alert did not successfully save. Please try again later.
S. Thongsuwan, A. Ranusawud, P. Limsuwan, S. Jaiyen, P. Buranasiri, "Investigation of direct metal laser sintering process of iron powder with low laser power," Proc. SPIE 10523, Laser 3D Manufacturing V, 105231C (26 February 2018); https://doi.org/10.1117/12.2299654